CASE Steiger 9380

A TRACTOR MODEL 9380

Standard Features

ENGINE:

6-Cylinder, Turbocharged aftercooled diesel 855 cu. in. displacement (14.0 liter) 400 Gross engine horsepower (at 2100 RPM)

· 348 (est.) PTO horsepower (measured at standard PTO speed)

Air-induction System:

Radial sea[ centrifugal pro-cleaner with exhaust aspirator

· Radial seal dry-type final air elements with

safety element and service indicator Fuel Tank: 270 gal. integrally built into rear frame Hood: tilt-up

Exhaust: vertical, mounted in line with cab corner post

Decelerator: foot operated

OPERATOR PROTECTIVE STRUCTURE:

Cab, rubber isolated, cushioned ROPS, constant flow cab pressurization, 3 speed fan, heater, air conditioner with HFC 134A refrigerant, aspirated cab air pro-cleaner; 50.75 sq. ft. of tinted glass; inside rearview mirror

Ashtray and cigar lighter

Seat: Case International "Comfort Master" air suspension, w/swivel, fore/aft isolator, gray cloth, 5 position left armrest, right armrest, lateral isolator, seat tilt angle, adjustable lumbar support, seat belts, adjustable dampening control and recliner

Steering Wheel: tilting and telescoping

Windshield Wipers: center front

Beverage cup holder

INSTRUMENTATION:

Centralized electronic dash display with digital tachometer for engine and PTO speed, digital speedometer and gear selector readout. Warning lights for low voltage, engine oil pressure, right and left turn signal, high beam indicator, on demand limited slip differential, park brake, hydraulic oil temp., engine coolant temp., transmission oil temp., engine coolant level, engine air cleaner, hydraulic filter indicator and transmission filter indicator Gauges mounted on the front, right hand cab post include hourmeter, voltmeter, engine water temp., engine oil pressure and fuel level. Right hand console plugs for non-optioned tractors

TRANSMISSION:

12-speed Synchro, 12 forward and 3 reverse speeds, manually operated, with fully synchronized range and speed, and a wet mounted master clutch, providing the capability to start in any gear.

BRAKES:

18" diameter disc mounted on the front axle

Brake is a dual caliper, dual piston hydraulically actuated system.

Parking Brake: manually applied integrated with the service brake

AXLES:

Double reduction outboard planetary

HYDRAULICS:

Closed center, load sensing, pressure compensating, 4 remotes standard, lever type (ISO) couplers. Each remote section two I)Oat, flow control, detents and kickouts. (One in cab flow control standard.)

Pump: 30 GPM (1 14 liter/min) at 21 00 RPM with 2900 PSI maximum operating pressure w/SyncroShift transmission (27 GPM (102.3) w/power shift transmission), 18 gallon reservoir

HYDRAULICS FOR STEERING:

Closed center, load sensing, steering control unit 30 GPM gear pump and priority valve

HITCH AND DRAWBAR:

Heavy-duty swinging telescoping type Drawbar

ELECTRICAL:

12 volt with 3 low maintenance batteries, 1875 total cold cranking amps. at O* F. 125 amp. alternator at rated engine speed with))t-)n regulator.

Lights: Halogen sealed beam lights, 6 front and 4

rear. Two rear taillights. Safety flasher with integral turn signals.

Automatic reset type circuit breakers

Power connectors for monitors: one on the gauge post, one inside the gauge cover and one by the B-post

OTHER STANDARD EQUIPMENT:

Cab access for implement wiring harness at lower right rear of cab.

Requirements for Operation

Tires and wheels are not standard equipment and must be ordered as required.

T